Very specific and what you could call “niche” post today. But I cannot be the only one to hit this obstacle so I’m sharing.  On a recent project  I hit a bit of a snag with this metal open ended zipper. (Who am I kidding. I hit a snag on EVERY project. Occupational hazard for a refashioner!) It was about an inch longer than I needed it to be. I’ve marked with chalk where I wanted the stoppers to be…
Shortening a standard closed and plastic zipper is pretty straightforward.  With this zip though, I couldn’t shorten from the bottom. (Damn). That’s where the fittings are that make this an open ended zipper. It’s chunky and the design I had in mind called for the the zip stops (at the top of the zip) to still be visible on the finished garment.  So simply sewing thread stoppers wasn’t going to cut it.  (double damn).
In some cases the fabric that encloses the end of the zipper at the top is sufficient to act as a stopper in itself. But in this instance that was not the case either….I couldn’t order another zip as the length I needed was not standard; and in any case, I much prefer to use what I have if I can. (Damn, damn, damn, damn, damn). So, in short (pun intended), I needed to shorten the zip from the top instead…
So if you ever find yourself in a similar position, here’s how to shorten an open ended metal zipper…
I needed to move this little sucker (above) down to where that chalk mark is. And this is one chunky metal zipper, so there was some serious brute force involved in this.
Before doing anything, Â unzip the zip about halfway down and create some makeshift stoppers with pins. If you’re anything like me you may inadvertently pull the zip pull straight off the top after you’ve removed the stoppers. Yes I have done that. After the zip was sewn into a garment. (Face palm).
You’ll need some jewellery pliers and side cutters for this…
Using the side cutters, and starting with the zipper tooth in front of your chalk mark, snip the end of the zip tooth off… then cut away as much of the rest of it as you can…
Then use the pliers to wiggle and remove what’s left…
Remove 5 or 6 teeth in this way, on both sides of the zip….
Cut away the excess zipper tape…
You’re left with these zipper stops on the parts you cut away. Now you CAN buy zipper repair kits like these. And there will be replacement zipper stops included in those. If those meet your needs you can skip the next couple of steps. But  I didn’t have time to order and wait for a kit to arrive (I was on a deadline and everything is right down to the wire right now). Plus, you know, that “working with what I have” thing in me!
This was by far the trickiest step. It’s on there pretty firmly so this is where the brute force part comes in. Use the pliers (A second pair comes in handy if you have them) to wiggle/lever/coax the zipper stop off the zipper tape. Not shown in this pic, but I found cutting away the zipper tape as close to the stopper as possible, and then fraying it, aided the process of loosening it’s grip a little. As did swearing.
Eventually you’ll get the little sucker off. Open it up slightly (2 sets of pliers again)…
Slide it onto the zipper tape in the position of the first tooth you removed and use the pliers to clamp it firmly in place. (Repeat for both sides of the zip)
Ta dah!
So yeah! Random I know. But someone, someday, is going to find this useful. You’re welcome 😉